True GDM-23, Руководство по установке

Страница: 6 / 35

............ www.truemfg.com ............
True Food Service Equipment, Inc.
SAFETY INFORMATION
4 4
The power cord from this appliance is equipped with
a grounding plug which minimizes the possibility of
electric shock hazard.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly grounded.
If the outlet is a standard 2-prong outlet, it is your
personal responsibility and obligation to have it replaced
with the properly grounded wall outlet.
The refrigerator should always be plugged into it’s own
individual electrical circuit, which has a voltage rating
that matches the rating plate.
This provides the best performance and also prevents
overloading building wiring circuits which could cause a
fire hazard from overheated wires.
Never unplug your refrigerator by pulling on the power
cord. Always grip plug firmly and pull straight out from
the outlet.
Repair or replace immediately all power cords that have
become frayed or otherwise damaged. Do not use a cord
that shows cracks or abrasion damage along its length or
at either end.
When removing the refrigerator away from the wall, be
careful not to roll over or damage the power cord.
If supply power cord is damaged it should be replaced
with original equipment manufacture parts. To avoid
hazard this should be done by a qualified service
technician.
HOW TO CONNECT ELECTRICITY
Do not, under any circumstances, cut or remove the ground prong from the power cord.
For personal safety, this appliance must be properly grounded.
WARNING!
USE OF ADAPTER PLUGS
NEVER USE AN ADAPTER PLUG! Because of potential safety hazards under certain conditions, we strongly recommend
against the use of an adapter plug.
North America Use Only!
NEMA plugs
TRUE uses these types of plugs. If
you do not have the right outlet have
a certified electrician install the correct
power source.
The incoming power source to the cabinet including any
adapters used must have the adequate power available
and must be properly grounded. Only adapters listed
with UL should be used.