TROY XCD MAN-EXT2000, Руководство администратора, Страница: 66 / 252

4-20 TCP/IP Network Configuration
$ MCR NCP
NCP>CONNECT VIA QNA-0 PHY ADD 00-40-17-00-01-07
On ULTRIX systems, you would execute
commands similar to the following example:
# addnode XCD -c qna-0 -h 00-40-17-00-01-07
# ccr XCD
On a NetWare system, you would use the
XCONFIG utility included with every TROY XCD
print server. Simply type XCONFIG at the DOS
prompt and select the desired TROY XCD print
server.
b. If you are using the remote console, you will get
the message
Console connected
(VMS) or
Connection established
XCONFIG) or
Remote console reserved
(ULTRIX). Press
RETURN and enter the password
ACCESS
in
response to the "#" prompt (it will not echo).
Note:
You will not be asked for a password if you
are using the XConnect II or XConnect 100 serial
port.
c. You will be prompted for a user name. Enter
anything in response to this prompt (older versions
do not ask for the user name).
d. You will then get the
Local>
prompt. Type
SET
IP ADDRESS ipaddress
, where
ipaddress
is the
desired IP address you wish to assign to the TROY
XCD print server (check with your network
manager for the IP address to use). For example:
Local> SET IP ADDRESS 192.189.207.3