Triumph Adler CLP 4526, Инструкция по эксплуатации

Страница: 103 / 156

3.13 Other Modes
3-63
7 77 7
Press the
U
or
V
key to increase or decrease the
value at the blinking cursor and set the desired time.
The time must be set between
000
and
495
seconds,
in 5-second increments. If set to
000
, printing will be
continued immediately without any time interval. You
can use the
Z
and
Y
keys to move the cursor right
and left.
8 88 8
Display the desired time and press the ENTER key.
9 99 9
Press the MENU key. The display returns to
Ready
.
3.13.10 Duplex Printing Error Detection
Setting
This setting is possible only when the optional DU-640
duplex unit is installed on the printer. This setting controls
whether or not the message
Duplex disabled Press
GO
appears when label or some other type of paper that is not
supported for duplex printing is specified as the paper type
when duplex printing is being performed.
When duplex printing error occurs when this setting is On:
•
Press the
GO
key to perform simplex printing.
• Press the
CANCEL
key to cancel the print job.
When duplex printing error occurs when this setting is Off:
•
Duplex printing is performed.
1
11
1
Press the MENU key.
2
22
2
Press the
U
or
V
key repeatedly until
Others >
appears.
3 33 3
Press the Z key.
4 44 4
Press the U or V key repeatedly until
>Finishing
Error >
appears.
5
55
5
Press the
Z
key.
6
66
6
Press the
U
or
V
key repeatedly until
>>
Duplex
appears.
7 77 7
Press the
ENTER
key. A blinking question mark (?)
appears.
8
88
8
Press the
U
or
V
key to change Off to On.
9
99
9
Press the
ENTER
key.
10 10 10 10
To exit the menu selection, press the
MENU
key.
3.13.11 Staple Error Detection Setting
This setting is possible only when the optional DF-600/610
finisher is installed on the printer. This setting controls
whether or not the message
Add staples
appears when
the finisher unit runs out of staples during output of a stabled
job.
When the finisher runs out of staples while this setting is On:
•
Message is displayed and printing pauses. Printing
resumes automatically when stables are replenished.
When the finisher runs out of staples while this setting is Off:
•
Message is displayed, but printing continues without
stapling.
1
11
1
Press the
MENU
key.
2 22 2
Press the U or V key repeatedly until
Others >
appears.
3 33 3
Press the
Z
key.
4 44 4
Press the
U
or
V
key repeatedly until
>
Finishing Error >
appears.
5 55 5
Press the Z key.
Others >
>Finishing >
Error
>>Duplex
Off
>>Duplex
? Off
Others >
>Finishing >
Error