Thermostatic electric shower
15
Control buttons
Apart from the START/STOP button, there are
two other control buttons – POWER and COLD.
The button marked
is for COLD water only.
When pressed the current display is replaced
by ‘CLD’
(fig.23)
. It remains in this state until
the power button is pressed. Adjusting the
temperature control at this setting has no effect
on the force of the water from the showerhead.
The button marked
is the POWER button
which is a toggle switch between full power and
economy power.
Economy is for using less power when the
ambient mains water temperature is high during
hot months.
If the shower is on full power and the power
button is pressed, the current display is replaced
by ‘ECO’ for five seconds
(fig.24)
. During this
time, the flow rate decreases to try to achieve
the same temperature as before.
Note:
If the setting was high at full power,
then it will not be possible to obtain the same
temperature on economy power. The shower
will try to provide the highest temperature at the
best flow rate.
Note:
If the stated flow rate required for the unit
cannot be met due to low water pressure, it will
be necessary to operate the shower on economy
power during hot months because of flow rate
limitations entering the unit.
Full is the maximum power setting which allows
the highest flow achievable for your preferred
temperature.
If the shower is on economy power or the
cold setting and the power button is pressed,
the current display is replaced by ‘FuL’ for five
seconds
(fig.25)
. During this time the flow
rate increases to achieve the same temperature
as before or to correspond to the current
temperature control position.
It is advisable to leave the power setting at full at
all times, except during periods of hot weather.
Fig.21
Fig.22
Fig.23
Fig.24
Fig.25
