Thermostatic electric shower
7
ImpoRtaNt:
If installing onto a tiled wall
always mount the unit on the surface of the
tiles. never tile up to the unit.
Refer to
fig.6
for correct siting of the shower.
Position the unit where it will NOT
be in direct
contact with water from the showerhead.
Position the shower unit vertically.
Allow enough room between the ceiling and the
shower to access the cover top screws.
Note:
Water regulations require the showerhead
be
‘constrained by a fixed or sliding attachment
so that it can only discharge water at a point
not less than 25 mm above the spill-over level
of the relevant bath, shower tray or other fixed
appliance’
. The use of the supplied soap dish will
in most cases meet this requirement, but if the
showerhead can be placed within a bath, basin
or shower tray, then a double check valve, or
similar, must be fitted in the supply pipework to
prevent back-flow.
ImpoRtaNt:
Using a suitable sealant, always
seal around the incoming pipework to
prevent water entering the wall.
Liquid Crystal Display
This shower unit has a LCD which has an
optimum viewing angle that is slightly below eye
level. Therefore position the unit so the display
is at nose level. For multiple users of varying
heights, an optimum shower height must be
arrived at.
Pressure relief safety device
A pressure relief device (PRD) is designed into
the shower unit which complies with European
standards. The PRD provides a level of appliance
protection should an excessive build up of
pressure occur within the shower.
DO NOT operate the shower with a damaged or
kinked shower hose, or a blocked showerhead
which can cause the PRD to operate.
Outline of bath
or shower tray
Mains cold water
supply - bottom,
top and back
Riser rail can
be mounted either
side of shower
25 mm minimum
Soap dish
retaining
ring
Spillover
level
Height of
showerhead
and
shower
to suit
user's
requirement
Shower unit
must not
be within
an area
1 metre
from base
Fig.6
Diagrammatic view (not to scale)
ImpoRtaNt:
the unit must be mounted
on a flat surface which covers the full width
and length of the backplate, otherwise
difficulty may arise when fitting the cover
and subsequent operation of the unit may
be impaired.
WaRNING!
the shower must not be positioned
where it will be subjected to freezing
conditions.
SITING OF THE SHOWER
SITING OF THE SHOWER
