Thermostatic electric shower
14
The shower controls are shown in
fig.17
.
CautIoN:
It is recommended that persons
who may have difficulty understanding or
operating the shower controls should not
be left unattended while using the shower.
Special consideration should be given to
young children and the less able bodied.
Make sure the water supply is turned fully on.
Switch the electric supply back on at the
isolating switch.
Immediately, the start up routine commences
and the display flashes all information for three
seconds
(fig.18)
.
The display then shows ‘OK’ in a blue backlight
(fig.19)
. It will remain in this standby mode
until the shower is started.
To start the shower
Press the START/STOP button
and water will
flow.
The display shows ‘FuL’
(fig.20)
indicating full
power is being used.
After a few seconds, two ‘up arrows’ start
flashing indicating the unit is working towards
its preset showering temperature
(fig.21)
. This
is achieved shortly when the display shows the
temperature as °C.
To stop the shower
Press the START/STOP button and the phased
shutdown will begin. The current temperature
and segments are replaced with a flashing ‘SD’
and ‘SHuTTING DOWN’ alternating on the
display
(fig.22)
. Water stops flowing after a few
seconds after which the display returns to ‘OK’.
The shower can be left in this standby mode
ready for the next immediate user, otherwise,
switch off at the isolating switch.
OPERATING THE SHOWER
OPERATING THE SHOWER
Power button
Cold button
Display
Start/Stop
button
Temperature
control
Fig.17
Fig.18
Fig.19
Fig.20
WaRNING!
Before normal operation of the
shower, it is essential that the
commissioning procedure has been
completed correctly.
