10
OPERATING THE SHOWER -
(fig.6)
Make sure the commissioning procedure
has been carried out.
To start the shower
• Turn the power selector to either
Cold
,
Economy
or
High
and the water will flow.
To stop the shower
• Turn the power selector to the
OFF
position.
• After stopping, the unit
MUST
be isolated via
the 45amp-isolating switch.
NOTE:
If restarting immediately after stopping be
aware that a slug of hot water will be expelled for
the first few seconds.
To use the power selector
The power selector has three ‘
ON
’ positions -
COLD, ECONOMY
and
HIGH
.
Cold setting
- single blue circle.
• The cold setting does not provide any heat
from the heater can to the incoming water.
Economy setting -
single red circle.
• Economy uses only one of the elements within
the heater can.
NOTE:
If the stated flow rate required for the unit
cannot be met due to low water pressure, it will
be necessary to operate the unit on this setting
during the warmer months because of flow rate
limitations entering the unit.
High Setting
- double red circles.
• High uses both of the elements within the
heater can.
IMPORTANT:
It will take a few seconds for the
temperature to stabilise once changes have been
made.
USER OPERATING INSTRUCTIONS
N-002-A
Note:
In normal use, it is in order to leave the
water supply permanently on to the shower
unit, but as with most electrical appliances,
the unit must be switched off at the
isolating switch when not in use.
Power selector
Cold
Economy
High
Temperature
control
COLDER
Fig.6
OFF
HOTTER
