Triton T300si, Инструкция по установке и эксплуатации

Страница: 19 / 32

T300si electric shower
Socket
for control
cable
Control
cable exit
Fig.
Fig.
Fig.9
Align the supplied fixing template (fig.)
with the 15 mm control cable hole already
drilled. Mark the four fixing holes marked ‘A’
on the template. Drill and plug using the plugs
supplied, or suitable cavity fixings.
Using the screws supplied, secure the mounting
bracket to the wall
(fig.) .
note: The mounting bracket must be fitted on
the surface of the tiles.
The control panel is connected to the remote
pack by means of a supplied length of control
cable complete with a plug at either end. Either
end of the cable can be plugged to the remote
pack PCB
(fig.) or the control panel PCB.
Cable entry into the control panel is via the
opening on the back of the main body of the
control panel. Remove the two screws and
remove the access panel
(fig.) to reveal the
connector socket.
Cable entry into the remote pack is through one
of the built in cut-outs.
Remove the protective dust covers from both
ends of the control cable.
Once the cable has been plugged into the socket
inside the control panel, refit the access panel,
making sure the cable exits through the slot at
the bottom corner of the access panel
(fig.9) .
ImporTAnT: enough free play should be left
in the cable to allow for future removal of the
control panel for servicing purposes.
Make sure the cable clamp in the remote pack is
used to secure the control cable
(fig.0) .
Do noT switch on the electricity supply
until the cover on the remote pack and
control panel have been fitted.
Hook the control panel over the lugs on the
Fig.
Fitting the control panel bracket
FITTING THE CONTROL PANEL
BRACKET
W-015-A
WARNING!
Under no circumstance should the
control cable be extended or
shortened, as not only will it impair
the performance of the shower but
will also invalidate the guarantee.