Triton T300si, Инструкция по установке и эксплуатации

Страница: 16 / 32

T300si electric shower
Route the heated water pipe to the outlet
position and push on the fittings as shown in
(fig.) . Connect the heated water pipe to
a ½” BSP x 15 mm female thread elbow or
straight coupler compression fitting
(fig.9) .
note: This fitting is not supplied as variations
in installations requires selection of the most
appropriate fitting.
Screw the supplied male-thread connector into
the female fitting
(fig.0) using PTFE tape to
give a watertight joint.
note: The male-thread connector supplied has
a shoulder. If fitting into a flush wall, make an
additional 8 mm allowance for this shoulder at
the finished surface. The connector can be cut to
size if required.
The threaded connector should protrude from
the wall surface between 8 mm and 13 mm.
Make good the wall.
The bulkhead and its cover are supplied
assembled. Separate the two halves by carefully
prising apart at the smaller of the two elbow
apertures.
Secure the elbow to the bulkhead body with the
three screws supplied
(fig.) .
Screw the bulkhead assembly onto the threaded
connector temporarily. Mark the position of the
two fixing holes
(fig.) securing the bulkhead
to the wall.
note: If screw thread protrudes too far out of
the wall, it can be cut to the correct length using
a hacksaw.
Unscrew and remove the bulkhead assembly.
Check the location of the pipe in the wall before
drilling.
Drill and plug the holes using the wall plugs
supplied.
(The wall plugs provided are suitable for
most brick walls — use an appropriate masonry
drill, but if the wall is plasterboard or a soft
building block, you must use special wall plugs and
an appropriate drill bit)
.
T00083
Fig.
Fig.
8mm − 13mm
Finis
hed surface
Appropriate
fitting
Heated water
pipe
Fig.9
Fig.0
Fitting the bulkhead
FITTING THE BULKHEAD