3
2. Installation
1
2
3
D
D
E
E
4
F
F
C
B
C
B
A
B
B
A
2.1 Mounting (Rack)
• Use the included rackmount shelves and mounting hardware to mount the UPS system
in a 4-post rack or rack enclosure. To mount the UPS system in a 2-post (telecom) rack,
order Tripp Lite’s 2-Post Rackmount Kit (model 2POSTRMKITWM, sold separately).
• The instructions in this manual are for common rack and rack enclosure types and may
not be appropriate for all mounting applications. The user must determine the fitness of
hardware and procedures before mounting. If hardware or procedures are not suitable
for the application, contact the manufacturer of the rack or rack enclosure for a
solution.
Warning: The UPS system is very heavy—be careful when moving or lifting it.
4-Post Mounting Procedure
1
The included plastic pegs
A
will support the
empty rackmount shelves
B
until the
permanent mounting hardware is installed.
Insert a peg near the center of the front and
rear bracket of each shelf as shown. (Each
front bracket has six holes and each rear
bracket has three holes.) The pegs will snap
into place.
After installing the pegs, expand each shelf to
match the depth of the vertical rack rails. The
pegs will fit through the square holes in the
rack rails to support the shelves. Confirm that
the shelves are level in all directions.
Note:
The support ledge of each shelf must face
inward.
2
Secure the shelves
B
to the rack rails
permanently using the longer included screws
and washers
C
as shown. (Place four screws
at the front and four screws at the back.)
Tighten all screws before proceeding.
Warning: Do not attempt to install
the UPS system until the required
screws have been inserted and
tightened. The plastic pegs will not
support the weight of the UPS
system.
3
Attach the mounting brackets
D
to the
forward mounting holes of the UPS system
using the shorter included screws
E
. The
mounting bracket ears must face forward.
4
With the aid of an assistant, lift the UPS system and slide it onto the mounting
shelves. Insert four of the included screws
F
through the mounting bracket ears and
into the vertical rack rails. Tighten all screws securely.
17-06-040-932882.indb 3
6/29/2017 10:33:19 AM
