Tripp Lite NGI-M05-C1, Руководство пользователя, Страница: 25 / 254

25

interface
Its command prompt is “
L2SWITCH(config-if)#”.
It means these commands can be executed in this command prompt.
In Configure code, executing command “ interface gigaethernet1/0/5 ” enter the
interface port 5 node.
Or
In Configure code, executing command “ interface fastethernet1/0/5 ” enter the
interface port 5 node.
Note: depend on your port speed, gigaethernet1/0/5 for gigabit Ethernet ports
and fastethernet1/0/5 for fast Ethernet ports.
L2SWITCH(config)#interface gigaethernet1/0/5
L2SWITCH(config-if)#

vlan
Its command prompt is “ L2SWITCH(config-vlan)#”.
It means these commands can be executed in this command prompt.
In Configure code, executing command “ vlan 2 ” enter the vlan 2 node.
Note: where the “2” is the vlan ID.
L2SWITCH(config)#vlan 2
L2SWITCH(config-vlan)#

acl
Its command prompt is “
L2SWITCH(config-acl)#”.
It means these commands can be executed in this command prompt.
In Configure code, executing command “ access-list test ” enter the access-list
test node.
Note: where the “ test ” is the profile name.
L2SWITCH(config)#access-list test
L2SWITCH(config-acl)#