Trilliant SecureMesh CONN-2000, Руководство по установке

Страница: 15 / 56

Notice: The contents of this document are proprietary and confidential and the property of Trilliant Holdings, Inc., its susidiaries, affiliates, and/or
licensors. This document is provided subject to the confidentiality obligations set forth in the agreement between your company and Trilliant. The contents
may not be used or disclosed without the express written consent of Trilliant.
15
Installation Guide for SecureMesh® CONN-2000 - PL-0689A
l
Ethernet surge suppressor: Citel: 521-R0655-01
l
IEEE802.3af compliant Power over Ethernet (PoE) injector: Tycon TP POE
48GD (Trilliant part # 409-0080-00)
l
For mounting the CONN-2000 on horizontal and vertical poles with an outside
diameter between 2 and 9 inches:
l
Wall mounting accessory bracket: HM-0395A
l
Worm-type hose clamp, 1/2 inches in width. The diameter should be
large enough to accommodate the pole and arrestor’s flange. See Fig-
ure 8 .
l
Self-fusing rubber insulation and sealing tape, such as Scotch
®
130C or 2228
rubber mastic tape
l
Electrical tape
l
Preferred: CAT5e cable (or better), 4 pairs, 100 Ohm, 26 AWG minimum
shielded (F/ UTP), 6.5 mm maximum OD, outdoor rated, UV protection
l
Exacto knife
l
Ground wire,10 AWG or larger, long enough to connect the device to the
primary ground point on the structure where the CONN-2000 is mounted
l
Shielded RJ45 plug: L-Com TDS8PC5
l
Ring crimp lug #10 ring 10 AWG wire: TE-2-36161-4
l
Cable ties or hook-and-loop wraps
l
RTV silicone
Replacement Parts
The device is not field-serviceable. If it is damaged, or a hardware fault or failure
occurs, replace the device. If faulty, the PoE injector can be replaced separately.