EASy IP EAS Network Receiver - Operation Manual
33
3. On the next screen, enter the IP address of
the Network Receiver that you wish to
upgrade, and then select the
CONTINUE
button.
4. The upgrade utility will verify what version
of firmware is installed in your Network
Receiver and notify you whether your
device needs a firmware upgrade. Select
the
CONTINUE
button to upgrade only the
files that are not current, otherwise, select
the
Program All Files
button to program
all Network Receiver files.
5. Once you have started the firmware
upgrade, the upgrade utility will show the
status of the upgrade. Once the upgrade is
complete, select the
OKAY
button.
6. It is recommended that you power-cycle
the EAS Network Receiver, making sure to
leave the power off for 5 seconds before
powering it back on. If you are not on-site,
the unit needs to be reset from the
System
tab by selecting the
RESET Hardware
button. For more information, see the
System Tab,
Resetting/Rebooting Your
Network Receiver
Section of this chapter.
7. After the Network Receiver has booted up,
verify that the configuration is correct, and
then from the
System
tab select the
Program Configuration
button to upload
the configuration to the Network Receiver.
8. If SNTP is not enabled, from the
System
tab select the
Upload PC Time
button to
set the correct system time.
