EASy IP EAS Network Receiver - Operation Manual
11
Overview of the EAS Network Receiver
Front Panel View
The front panel of the EAS Network Receiver includes the following LEDs for
DECODER 1
and
DECODER 2
:
A.
PWR
- This LED will illuminate when DC power is applied to the corresponding
Network Receiver.
B.
STATUS
- This LED will flash when the corresponding Network Receiver is functioning.
C.
FAULT
- This LED will illuminate or flash when there is a problem detected with the
corresponding Network Receiver.
D.
CH1
- When Channel 1 is configured to use the radio tuner and the radio signal
strength is acceptable, this LED will illuminate. When Channel 1 is configured as an
audio input, this LED turns off when no audio is being received. The LED flashes when
EAS messages are being received.
E.
CH2
- When Channel 2 is configured to use the radio tuner and the radio signal
strength is acceptable, this LED will illuminate. When Channel 2 is configured as an
audio input, this LED turns off when no audio is being received. The LED flashes when
EAS messages are being received.
A B C
D E
A B C
D E
Note:
The EAS Network Receiver chassis is capable of housing two
Network Receivers. This allows four radio or baseband audio inputs in a
single chassis. Each Network Receiver in a two unit chassis is
connected and configured separately.
