16
2. Press the Jog dial or Side button to end the
connection test. All the outputs will be turned
off.
When you have completed the configuration, the
Thermostat will enter Normal Operation and you
will see this display on the Thermostat.
Note:
• To stop and exit the Start-Up Configuration, press and hold the Side button for approximately
5 seconds.
• The output terminals are tested in a predefined sequence to ensure the safety of your
HVAC equipment. As such, after you have tested a specific output and proceeded to the next, you
are not allowed to test the previous output again. If you need to retest the previous output, reenter
the Start-Up Configuration as follows: Press and hold the Side button for approximately 10 seconds.
It will restart from Step 01 (or Step 02 if the Thermostat is already connected to Wi-Fi).
• If there is no input for more than one minute in each of the steps from Step 02 to Step 05, the
Thermostat will exit the Start-Up Configuration and return to Normal Operation.
Fig 16-A
Содержание TS2501
