TRENDnet TEW-829DRU, Руководство пользователя, Страница: 33 / 117

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-829DRU
26
UPnP and NAT-PMP
Services > UPnP
UPnP (Universal Plug and Play) and NAT-PMP (NAT Port Mapping Protocol) allows
devices connected to a network to discover each other and automatically open the
connections or services for specific applications (e.g. instant messenger, online gaming
applications, etc.) UPnP and NAT-PMP is disabled on your router by default and should
only be enabled to allow specific applications required by your computers or devices to
allow connections through your router as they are needed.
1. Log into your router management page (see “ Access your router management page ”
on page 8).
2. Click on Services and click on UPnP / NAT-PMP.
3. Under the UPnP / NAT-PMP section, check the Enable UPnP / NAT-PMP functionality
option. Click Apply to save and commit the changes.
Note: When UPnP/NAT-PMP is enabled, you can check the currently open connections in
the UPnP/NAT-PMP entries table..
Static routes
Network > Routing
You may want set up your router to route computers or devices on your network to
other local networks through other routers. Generally, different networks can be
determined by the IP addressing assigned to those networks. Generally speaking and for
the case of this example, your network may have 192.168.10.x IP addressing and
another network may have 192.168.20.x IP addressing and because the IP addressing of
these two networks are different, they are separate IP networks. In order to
communicate between the two separate networks, static routing needs to be
configured.
1. Log into your router management page (see “ Access your router management page ”
on page 8).
2. Click on Network and click on Routing.
3. Review the Routing section. Click Add to add the new static route. Click Apply to save
and commit the changes.

Interface – Select the interface to assign the route.

Target Host-IP or Network: Enter the IP network address of the destination
network for the route. (e.g. 192.168.20.0)

IP4-Netmask: Enter the subnet mask of the destination network for the
route.(e.g. 255.255.255.0)

IPv4-Gateway: Enter the gateway to the destination network for the route.
(e.g. 192.168.10.2)

Metric: Enter the metric or priority of the route. The metric range is 0-9999, the
lowest number 0 being the highest priority.
You can check the current routing table under Status > Routes under Active IPv6-
Routes.