1
3
2
4
1
3
2
4
22
ENGLISH
Instructions for Use
• Regeneration
When the bicycle regenerates electricity for the battery, the system is in generation mode.
There are four levels of regeneration. The level of regeneration is shown by the arrows at the bottom
of the screen. To increase the regeneration level, press button ‘-’. For regenerative level 1 press once.
Press again to increase the regeneration level to a higher level. For a lower regeneration level press
button ‘+’.
To switch from any level of Assistance to the first regenerative level, press and hold the ‘
-
’ button.
To switch from any level of regeneration to the first assist level, press and hold the ‘
+
‘ button. The
‘
G
’ and the arrow will appear on the display during generation of energy.
• Distance, Odometer, Chronometer, Average speed, Clock
The right bottom corner of the screen shows the distance,
odometer, chronometer, and average speed (Order of appearance:
trip distance, odometer, average speed, time of day). Press
button to switch modes. To reset distance, chronometer, or
average speed, keep this button pressed for 2 seconds.
• Switching lights On / Off
Press the
,
button for 2 seconds to switch On / Off the
Controller display light, and, if present, the front and rear lights.
The lights will stay on even when you stop. Once activated,
the text “light on” appears on the screen. Even when the
battery-gauge shows ‘empty’, there is enough energy to run the
lights for about two hours. If the battery-pack is fully drained, the lights will be powered by the
system as it switches to generative mode automatically.
To switch the lights off, hold the
,
button for 2 seconds.After switching off, the text “light off”
will appear on the screen.
