Trejon Optimal DS1300, Инструкция по эксплуатации и техническому обслуживанию

Страница: 25 / 36

Operating manual DS1300, DS1500, DS2500 (1001)
trejonindustries.se 25
Use the table below for the correct torque settings of bolts and nuts of the equipment.
Dimension
Classification 8,8 Classification 10,9
Nm Ib.ft. Nm Ib.ft.
M8 25 18 35 26
M10 50 37 70 52
M12 90 66 125 92
M14 140 103 200 148
M16 215 155 305 225
M18 295 217 420 309
M20 420 302 590 438
When locking nuts are used, increas torque with 5%
Table with recommended torque settings of bolts and nuts.
4.2 Maintenance schedule
Position Interval Type Points Notes
Feeding auger 40h Grease 2pcs
Mixer 40h Grease 2pcs
Chain transfer 40h Rub the oil or
grease in, using a
brush.
1pcs
Chain tension
sprocket
40h Control / adjust 1pcs Check the tension of the chain. You
must be able to press the chain down
7 mm. The transfer system must work
smoothly, without creaking.
Torque setting for
bolts and nuts
40h Check See table above for setting
Use grease NLGI 2 with EP-qualities for lubricating.
Do NOT use “graphite-grease” for the ball bearing. Don’t use a pneumatic grease gun to lubricate sealed
bearings; the seal can loosen or be damaged. Clean lubrication nipples before lubrication.
Always lubricate after cleaning with water.
Chain will be possible to
press down 7mm
Chain tensing
sprocket
(fig.10)
Picture shows shows chain transfer with chain tensioner