TransAct POSJET 1500, Руководство программиста

Страница: 146 / 294

Control Codes POSjet
®
1500 Programmer's Guide
Page 132 Rev M Nov-07
Width X
2.5” Max
520 dots
2.5” Max
520 dots
2.25”
468 dots
2.0”
416 dots
1.75”
364 dots
0.5” Min.
96 Dots
Offset O 0”
0 dots
0”
0 dots
0.25”
52 dots
0.5”
104 dots
0.75”
156 dots
2.0”
416 dots
Height
14
Y 0.5” Min.
96
4.125”
792 dots
4.5
864 dots
5.1
984 dots
5.875 Max
1128 dots
6.125 Max
1176 dots
In inches Height = 10.3125/Width In dots Height = 411,840/Width
Width = 10.3125/Height Width = 411,840/Height
Table 36 Max/Min Page Mode Height, Width, and Offsets
Note: If an image can not be set smaller than 0.5” or 96 dots in height or width, the image will be adjusted up to
meet the minimum size requirements.
Page Definition
Before you start the page definition, you must set the page size. (See the [ESC]u command) Once the page size is
defined, the [ESC]t command will start page definition and define the initial orientation. An [ESC]t command
during page definition will change the orientation and reset the entry location back to the top left corner of that
orientation.
Receipt or
Inserted Form
B
>
>
>
>
>
A > > > > >
D
>
>
>
>
>
C > > > > >
Initial entry
location
Figure 28 Page Mode entry Orientations
Embedding Station Selects during Page Definition
The POSjet

1500 supports station select and form loading commands during the page mode definition. The station
select commands will be stored and delayed until after the definition is complete and the printing process begins.
The advantage of this is that it allows the page to be sent to the printer and processed while the operator is preparing
to insert a form.
This station select process follows rules based on the order that the station select commands are presented during the
page definition.
1) If a receipt station select precedes a validation select command, the validation select command will be ignored.
If a form is in the printer, it will be ejected before printing starts.
14
The image array height must be allocated in multiples of 12. Therefore the height specified will be rounded (up
if there is room or down if not) to the nearest multiple of 12.