TransAct BANKjet 1500, Руководство оператора

Страница: 35 / 74

2 2 2 2
Revision E
:=
$ ? ! $ ? ! $ ? ! $ ? !
The BANKjet 1500 is designed to run validation either by using application software, or manually. Forms can be
inserted in either horizontal or vertical orientation. Regardless of the orientation, the insertion process is the same.
The BANKjet 1500 can accept forms with measurements between 2.75" x 2.75" (69.8mm x 69.8mm) and 8.5" x 11"
(215.9mm x 279.4mm).
1.
Send appropriate control commands from your system to initiate the validation process or press the
! ",
button to enter validation mode.
2.
When the
! ", $ $ ) " <$ )
starts blinking, insert the validation paper into the validation paper inlet using
the right edge of the validation paper inlet as a guide.
3.
When the validation sheet is detected by the sensors, the
! ", $ $ ) " <$ )
changes from blinking to
steady ON. The paper is automatically drawn into the printer, and printing begins.
4.
When the
! ", $ $ ) " <$ )
begins to blink again after printing, remove the validation paper.
. 5 & %! . 5 & %! . 5 & %! . 5 & %!
The side of the inserted form that is facing the front end of the printer is where the printing will always occur.
Always insert forms so that the side of the form that you want the printing to occur on is facing the front of the
printer.