8
BAS-SVN208G-EN
Step 11: Air-Fi
®
Wireless Setup
Note:
The network must be open for a WCS to join the network, but does not need to
be open for the WCS to be manually assigned to a controller.
WCS: Network Joining and Controller Association
After addresses are set, the WCS will immediately attempt to join the network and
associate with the controller.
• Error code E2 will appear on the sensor display until the WCS successfully joins the
network. Until network joining is successful, the WCS will repeat its attempt to join
every 60 minutes.
• Association between the WCS and the controller will automatically be initiated. The
WCS will repeat its attempt to associate every 15 minutes until successful. Error
code E1 will be displayed until association is successful.
• You can press the center button twice at any time to cause the WCS to re-attempt
to join the network and to associate with the WCI.
Adding Additional WCIs to an Existing Network
1. Press the OPEN_NET button on the System Controller WCI to open the network for
joining for one hour. Every member WCI will indicate that the network is open. Any
WCI with a correct rotary address setting that is located within radio range of a
network member, will join the network.
Note:
Pressing the OPEN_NET button on a member WCI will open only that one WCI.
2. Observe the green NWK LED illuminate on a WCI that joins the network.
Related Literature
• BAS-SVX40: Air-Fi
®
Wireless System Installation, Operation, and Maintenance:
Describes how to address, install, modify, and troubleshoot an Air-Fi
®
Wireless
system.
• X39641264001: Air-Fi
®
Wireless Communications Interface (WCI) Installation
Instructions: A quick-start guide to addressing and installing a WCI.
• X39641265001: Air-Fi
®
Wireless Communications Sensor (WCS) Installation
Instructions: A quick-start guide to addressing and installing a WCS.
• X39641266001: Air-Fi
®
Wireless Communications Sensor (WCS) Configuration
Instructions: A quick-start guide to configuring a WCS.
