9
A
B
Electrical board door
Front panel
Do not exceed the maximum inclination allowed, as shown in the figure.
•
Insert the forks from the side to avoid damaging the panels.
•
Before placing the machine on the ground remove the wooden supports.
2.5.2
Lifting with a crane
2.6
Unpacking
It is recommended to use a system to prevent the belts from slipping from the bars during
lifting.
Place spacers and protectors in between prevent damaging the unit.
•
Insert the lifting bars into the arranged holes on the base and indicated by the relative labels.
•
Lift the unit using suitable belts.
Make sure that all the equipment used for handling (belts, bars, etc.) are appropriate for
the weight of the unit.
•
Remove the wooden supports before resting it definitely on the ground.
•
Remove the clear film that wraps the machine.
•
Remove the corner protectors.
The machine is supplied without shock absorbers. Install any shock absorbers before
setting the machine on the ground.
Only remove the packaging when set in the place of installation.
2.7
Access to internal parts
A
B
C
Bar for lifting (maximum ø 63 mm)
Hole to insert the lifting bar
Label for holes enabled for lifting
A
B
Wooden support
Corner protector
