30
System Programming SETUP
1. Press the NEXT key to display Generic BAS Binary Output
2 Definition screen.
2. Press the + or - key until the proper value is displayed.
Used on Units:
With GBAS 0-5VDC Module
3. Press the ENTER key to confirm this choice.
Possible Values:
Output is Not Assigned
4. Press the NEXT key to display Generic BAS Binary Output
Indicate Selected Diag Alarms
3 screen.
Indicate Unit at Max Capacity
5. Press the + or - key until the proper value is displayed.
Indicate any comp is running
6. Press the ENTER key to confirm each choice.
7. Repeat steps 1 - 4 to display Generic BAS Binary Output
screens 3, 4 & 5.
8. Press the NEXT key to advance to the following screen.
1. Pressing the NEXT key will display the beginning of
the Submenu.
2. Press the NEXT key again to advance to the following screen.
This screen is displayed when GBAS 0-10 VDC Module is installed
1.To view the factory preset or to modified the factory presets
to meet specific application requirements, press the
ENTER key. If no adjustments are required, press the NEXT
key to advance to the "CGM Alarm Output Diagnostic
Assignments"
2. Press the + or - key until the proper value is displayed.
Used on Units:
With GBAS 0-10VDC Module
3. Press the ENTER key to confirm this choice.
Possible Values:
Not Assigned
4. Press the NEXT key to display Generic BAS Analog Input
Leaving Solution Setpoint
2 screen.
Ice Build Terminate Setpoint
5. Press the + or - key until the proper value is displayed.
Hot Start Load Limit Setpoint
6. Press the ENTER key to confirm each choice.
Capacity Limit Setpoint
7. Repeat steps 1 - 4 to display Generic BAS Analog Input
screens 2, 3 & 4.
8. Press the NEXT key to advance to the following screen.
1. Press the + or - key until the proper value is displayed.
Used on Units:
With GBAS 0-10VDC Module
2. Press the ENTER key to confirm this choice.
Possible Values:
Output is
Not Assigned
3. Press the NEXT key until the following screen is displayed.
Indicate Selected Diag Alarms
Indicate Unit at Max Capacity
The following screen will display if "Indicate selected diag
Indicate any comp is running
alarms" is assigned.
1.To view the factory preset or to modified the factory presets
to meet specific application requirements, press the
ENTER key to advance to the following screens. If no
adjustments are required, press the NEXT key to advance to
the GBAS Analog Output Assignment screen.
End of Submenu (NEXT) to Re-enter SETUP
GBAS 0-10VDC Module I/O Assignments
Press ENTER to Review or Adjust
GBAS (0-10VDC) Analog Input 1 Assignment
NOT ASSIGNED
GBAS (0-10VDC) Binary Output Definition
OUTPUT IS NOT ASSIGNED
GBAS (0-5VDC) Binary Output 2 Definition
OUTPUT IS NOT ASSIGNED
GBAS (0-10VDC) Output Alarm Assignments
Press ENTER to Review or Adjust
Содержание IntelliPak CGAF Series
Страница 68: ...68...
