59
TRAK Machine Tools
Southwestern Industries, Inc.
TRAK 3ntr 3D Printers
–
Maintenance & Troubleshooting Manual
Figure 6.8.8 Invert Inlet & Outlet on Pump/Reservoir
4)
Put one teaspoon baking soda into reservoir
5)
Fill reservoir with distilled water
6)
Turn on machine
7)
Don’t
let the level go too low on reservoir. Use emergency button to stop.
8)
Once water level is steady on reservoir, let it run for 1-2 h
9)
Completely drain machine
10)
Refill with distilled water
11)
Run for 5 minutes
12)
Completely drain machine
13)
Revert piping (inlet outlet) on pump/reservoir to original configuration.
14)
Refill with printer cooling fluid (the red one)
