TracVision M1-c, Руководство пользователя

Страница: 26 / 55

TracVision M1 User’s Guide
27
Chapter 4 - Setup
8. Once the Check Switch test is complete, refer to the
table in Figure 12 and verify the values displayed on
your TV match those required for your selected service.
If your values match : Exit the menu and allow the receiver to
download the program guide.
If your values do not match, and you selected Single-Sat
mode : It is normal for your TV to show “No Switch Detected,”
“Switch Type Unknown,” or a similar error message. No action
is required.
If your values do not match, and you selected Dual-Sat mode :
Reset the system (follow the process on page 36 ), then repeat
the entire ExpressVu setup process, starting with Step 1 on
page 25 .
Figure 12 Expected Check Switch Results
ExpressVu Dual-Sat Results
Additional Receiver(s) - Run One Check Switch Test
If any receivers are connected to the “Stacked Output” jack on the
interface box, follow these steps to run a single Check Switch test on
each additional receiver, one at a time.
1. Temporarily disconnect the primary receiver from the
“Unstacked Output” jack on the interface box. Connect
the additional receiver in its place.
2. Perform Steps 1-5 on page 26 to run the test.
3. Wait 15 minutes, then verify that the values displayed
on the TV match those shown in Figure 12. If the values
do not match, and the system is set to Dual-Sat mode,
try running another Check Switch test. If your system is
set to Single-Sat mode, an error message will appear
instead; this is normal.
Input
1 1 2 2
Satellite
91 91 82 82
Polarity
Odd Even Odd Even
Status
Reception Verified
Switch
SW21