TracVision M1 User’s Guide
15
Chapter 2 - Operation
Automatic Switching
All operating modes provide automatic satellite switching using the
primary receiver (the receiver connected to the “Unstacked Output”
jack on the interface box). The antenna will automatically switch
satellites as you change channels using the primary receiver’s remote.
NOTE:
The receiver might take up to 30 seconds to display video when
changing channels, switching between satellites, and/or switching between
standard-definition and high-definition channels.
NOTE:
DISH Network receivers may switch to a different satellite on their
own in response to a blockage condition. For example, if the antenna’s view of
the 110 satellite becomes blocked for over a minute, the receiver may try
switching to the 119 satellite. If this occurs, you will see an error message on
the TV. Once the antenna can see the selected satellite again, the receiver will
automatically switch back and the error message will disappear.
How Switching Satellites Affects Additional Receivers
The TracVision system tracks one satellite at a time. Therefore, if you
switch satellites using the primary receiver, televisions connected to
other receivers might display different programming, no
programming, or an error message. Simply select a channel carried by
the new satellite, or use the primary receiver to switch back to the
original satellite. Only the primary receiver controls satellite selection.
Manual Switching
If you set up the system to track a custom set of satellites in Manual
mode, you can use the interface box to switch among them. Simply
press the CHANGE button until the display shows the desired
satellite. Then press ACCEPT.
