Trace2O AquaSafe WSL25 Plus, Инструкция по эксплуатации

Страница: 19 / 85

3.3.5 User defined Program (Fig 1.4)
This mode will run an incubation cycle at the user defined temperature for 24 hours. Adjusting the
user defined temperature is described in section 3.3.8. The timer can be altered to any setting
between 0 and 24 hours. Adjusting the incubation time is described in section 3.3.7.
Pressing and holding the middle switch for 5 seconds will start the incubation cycle and the screen
will change to the following:
The asterisk preceding the temperature will switch on and off indicating the status of the heater.
To stop or pause the incubation cycle press and hold the middle switch again for 5 seconds. The
display will return to the one shown in Fig 1.2.
3.3.6 Resetting the timer (Fig 1.5)
In this mode pressing the middle switch will display the following screen which will flash rapidly to
warn the user this will reset the timer and the elapsed time data will be lost:
The time remaining is displayed in the top left corner. This can be reset to the programmed
default cycle time by pressing the middle switch. After the switch press it will jump to the screen
shown in Fig 1.1. Should this mode be entered by mistake do not press the middle button. Turn
off the incubator and then turn back on which will exit this mode and return to the menu without
resetting the timer.
20.9°C 24:00
U->##° MEM 10.5v
20.9°C 24:00
New <SEL 10.5v
15:45 TIMER A
RST
*20.9°C 24:00
U->##° RUN! 10.5v