TQC AB3075, Руководство пользователя

Страница: 23 / 56

23
ANNEX A | INSTALLATION OF THE VACUUM BED
After unpacking the TQC automatic Film applicator the rubber seals for the vacuum bed need to
be placed. Without these seals the vacuum can NOT be created.
Remove all tape holding the Perforated- or Double Channel Vacuum Bed. Take great care to
remove all the tape.
Remove the vacuum bed from the base bed, and stow it in a safe place.
Take the two black rubber rings from the package and differentiate in size*.
Place the smallest of the rings (A4)* around the inner supports and the largest (A3) around the
outer supports, as shown in below image (detail A).
Gently lower down the vacuum bed (B or C). Take care not to disturb the placement of
the rubbers.
Turn the device on and follow the instruction to start a new test, using an A3 test chart, however
hold at the step where the vacuum pump turn on.
Place an A3 test chart and press it down. It should be sucked to the vacuum bed. If not grab the
sides of both the base plate and the vacuum bed and press them together.
When the pitch of the vacuum pump changes and sounds softer the vacuum seal is complete.
Continue the run and afterwards you are ready.
* When installing double channel only place A3 ring
4A
C B
3A
Detail A scale 1:1
EN