33
5.3
protocol-vlan group
Description
The
protocol-vlan
command is used to add the port to a specified protocol
group. To remove the port from this protocol group, please use
no
protocol-vlan group
command.
Syntax
protocol-vlan group
index
no protocol-vlan group
index
Parameter
index
—— Specify the protocol group ID.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Add Gigabit Ethernet port 1/0/20 to protocol group 1:
T1600G-52TS(config)#interface gigabitEthernet
1/0/20
T1600G-52TS(config-if)#protocol-vlan group 1
5.4
show protocol-vlan template
Description
The
show protocol-vlan template
command is used to display the
information of the Protocol-based VLAN templates.
Syntax
show protocol-vlan template
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Содержание T1600-28TS
