161
19.11
bandwidth
Description
The
bandwidth
command is used to configure the bandwidth limit for an
Ethernet port. To disable the bandwidth limit, please use
no bandwidth
command.
Syntax
bandwidth
{[
ingress
ingress-rate
] [
egress
egress-rate
]}
no bandwidth
{ all | ingress | egress
}
Parameter
ingress-rate
—— Specify the bandwidth for receiving packets. Range:
1-1000000Kbps for the gigaport.
egress-rate
—— Specify the bandwidth for sending packets. Range:
1-1000000Kbps for the gigaport.
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet / interface port-channel / interface range port-channel)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the ingress-rate as 5120Kbps and egress-rate as 1024Kbps for
port 1/0/5:
T1600G-52TS(config)#
interface gigabitEthernet
1/0/5
T1600G-52TS(config-if)# bandwidth ingress
5120
egress
1024
19.12
clear counters
Description
The
clear counters
command is used to clear the statistics information of all
the Ethernet ports and LAGs.
Syntax
clear counters
clear counters interface
[
gigabitEthernet
port
] [
port-channel
lagid
]
Содержание T1600-28TS
