TP-Link T1600-28TS, Справочное руководство CLI

Страница: 314 / 365

298
Parameter
multiplier
—— Configure the Hold Multiplier parameter. It ranges from 2 to 10.
By default, it is 4.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Specify Hold Multiplier as 5:
T1600G-52TS(config)#lldp hold-multiplier 5
30.3 lldp timer
Description
The lldp timer command is used to configure the parameters about
transmission. To return to the default configuration, please use no lldp timer
command.
Syntax
lldp timer { tx-interval
tx-interval |
tx-delay
tx-delay |
reinit-delay
reinit-delay
|
notify-interval
notify-interval |
fast-count
fast-count
}
no lldp timer { tx-interval | tx-delay | reinit-delay | notify-interval | fast-count }
Parameter
tx-interval
—— Configure the interval for the local device to transmit LLDPDU
to its neighbors. The value ranges from 5 to 32768 and the default value is 30
seconds.
tx-delay
—— Configure a value from 1 to 8192 in seconds to specify the time
for the local device to transmit LLDPDU to its neighbors after changes occur
so as to prevent LLDPDU being sent frequently. By default, it is 2 seconds.
reinit-delay
—— This parameter indicates the amount of delay from when
LLDP status becomes "disable" until re-initialization will be attempted. The
value ranges from 1 to 10 and the default value is 3.
notify-interval
—— Specify the interval of Trap message which will be sent
from local device to network management system. The value ranges from 5
to 3600 and the default value is 5 seconds.