Figure11-8 Create Extend-IP Rule
The following entries are displayed on this screen:
¾
Create Extend-IP ACL
ACL ID:
Select the desired Extend-IP ACL for configuration.
Rule ID:
Enter the rule ID.
Operation:
Select the operation for the switch to process packets which match
the rules.
z
Permit: Forward packets.
z
Deny: Discard Packets.
S-IP:
Enter the source IP address contained in the rule.
D-IP:
Enter the destination IP address contained in the rule.
Mask:
Enter IP address mask. If it is set to 1, it must strictly match the
address.
IP Protocol:
Select IP protocol contained in the rule.
TCP Flag
：
Configure TCP flag when TCP is selected from the pull-down list
of IP Protocol.
S-Port:
Configure TCP/IP source port contained in the rule when
TCP/UDP is selected from the pull-down list of IP Protocol.
D-Port:
Configure TCP/IP destination port contained in the rule when
TCP/UDP is selected from the pull-down list of IP Protocol.
DSCP:
Enter the DSCP information contained in the rule.
IP ToS:
Enter the IP-ToS contained in the rule.
IP Pre:
Enter the IP Precedence contained in the rule.
143
