Toyota ZZT230 series, Руководство по ремонту

Страница: 438 / 821

)
N
Dl-227
OlAGNOSTICS
-
AUTOMATIC TRANSAXLE
Neutral Basic
Line
007267
(e)
Inspect and adjust the shift lever position.
When shifting the shift lever from the
N
position to other
positions, check that the lever can be shifted smoothly
and accurately to each position and that the position indi­
cator is not aligned with the correct position.
If the indicator is not aligned with the correct position, carry out
the following adjustment procedures.
(1) Loosen the nut on the shift lever.
(2) Push the control shaft fully downward.
(3)
Return the control shaft lever 2 notches to N posi­
tion.
(4)
Set the shift lever to
N
position.
(5)
While holding the shift lever lightly toward the R
position side, tighten the shift lever nut.
Torque: 13 N·m (130 kgl·cm,
9
11-ibl)
(6) Start the engine and make sure that the vehicle
moves forward when shifting the lever from the
N
to
D position and reverses when shifting it to the
A
position.
(f)
Inspect and adjust the park/neutral position.
Check that the engine can be started with the shift lever
only in the N or P position, but not in other positions.
If it is not as stated above, carry out the following adjustment
procedures.
{1) Loosen the park/neutral position switch bolt and set
the shift lever to the
N
position.
(2) Align the groove and neutral basic line.
(3)
Hold in position and tighten the bolt.
Torque: 5.4 N·m (55 kgl.cm,
48
l n. l bl
)
For continuity inspection of the park/neutral position
switch, see page Dl-261 .
(g) Check the idle speed.
Idle speed: 750
±
50 rpm
(In N position and air conditioner
OFF)
7. MECHANICAL SYSTEM TESTS
(a) Measure
the stall speed.
The object of this test is to check the overall performance of the transaxle and engine by measuring
the stall speeds in the D and R positions.
NOTICE:
•
Do the test at normal operating fluid temperature 50 - 80 ·c (122 - 176 "F).
•
Do not continuously run this test longer than 10 seconds.
•
To
ensure safety, conduct this test In a wide, clear level area which provides good traction.
•
The stall test should always
be
carried out In pairs. One technician should observe the condi­
tions of wheels or wheel stoppers outside the vehicle while the other is doing the test.
(1)
Chock the
4
wheels.
(2) Connect an
OBD
II scan tool or
TOYOTA
hand-held tester to DLC3.
(3)
Fully apply the parking brake.
(4)
Keep your left foot pressed firmly on the brake pedal.
(5)
Start the engine.