Toyota ZZT230 series, Руководство по ремонту

Страница: 375 / 821

01-164
OK if hot
-
AUTOMATIC TRANSAXLE
AT3�\7
(5)
With the engine idling, check the fluid level. Add
fluid up to the COOL level on the dipstick.
(6) Check the fluid level at the normal operating tern�
perature,
70 -
80 "C
( 1 58 -
176
�F),
and add as
necessary.
NOTICE:
Do
not overfill.
(d) Check the fluid leaks.
Check for leaks in the transaxle.
If there are leaks, it is necessary to repair or replace o-rings,
gaskets, oil seals, plugs or other parts.
(e) Inspect and adjust the shift lever position.
When shifting the shift lever from the N position to other
positions, check that the lever can be shifted smoothly
and accurately to each position and that the position indi­
cator is not aligned with the correct position.
If the indicator is not aligned with the correct position, carry out
the following adjustment procedures.
(1) Loosen the nut on the shift lever.
(2)
Push the control shaft fully downward.
N
Bolt
N
Neutral Basic
Line
007257
(3) Return the control shaft lever 2 notches to N posi­
tion.
(4)
Set the shift lever to N position.
(5)
While holding the shift lever lightly toward the R
position side, tighten the shift lever nut.
Torque: 13 N.m (130 kgf.cm, 911-ibl)
(6)
Start the engine and make sure that the vehicle
moves forward when shifting the lever from the N to
D
position and reverses when shifting it to the R
position.
(f) Inspect and adjust the park/neutral position.
Check that the engine can be started with the shift lever
only in the N or P position, but not in other positions.
If it is not as stated above, carry out the following adjustment
procedures.
(1)
Loosen the park/neutral position switch bolt and set
the shift lever to the N position.
(2)
Align the groove and neutral basic line.