Toyota COROLLA CROSS, Руководство пользователя

Страница: 253 / 612

253
4-5. Using the driving support systems
4
Dr
iv
ing
■
The system can be operated
when
●
The engine switch is in ON.
●
Intuitive parking assist function is
on.
●
The vehicle speed is less than
about 6 mph (10 km/h).
●
A shift position other than P is
selected.
■
Setting the buzzer volume
The buzzer volume can be adjusted
on the multi-information display.
(

P.94)
■
If “Clean Parking Assist Sen-
sor” is displayed on the
multi-information display
A sensor may be covered with water
drops, ice, snow, dirt, etc. Remove
the water drops, ice, snow, dirt, etc.,
from the sensor to return the system
to normal.
If a sensor is dirty, the position of the
dirty sensor will be shown on the
display.
Due to ice forming on a sensor at
low temperatures, a warning mes-
sage may be displayed or the sen-
sor may not be able to detect an
object. Once the ice melts, the sys-
tem will return to normal.
If a warning message is displayed
even if the sensor is clean, there
may be a sensor malfunction. Have
the vehicle inspected by your Toyota
dealer.
■
If “Parking Assist Unavailable”
is displayed on the multi-infor-
mation display
Water may be continuously flowing
over the sensor surface, such as in
a heavy rain. When the system
WARNING
●
Do not attach a sticker or install
an electronic component, such
as a backlit license plate (espe-
cially fluorescent type), fog
lights, fender pole or wireless
antenna near a radar sensor.
●
Do not subject the surrounding
area of the sensor to a strong
impact. If subjected to an
impact, have the vehicle
inspected by Toyota dealer. If
the front or rear bumper needs
to be emoved/installed or
replaced, contact a Toyota
dealer.
●
Do not modify, disassemble or
paint the sensors.
●
Do not attach a license plate
cover.
●
Keep your tires properly
inflated.
■
When to disable the function
In the following situations, disable
the function as it may operate
even though there is no possibility
of a collision.
●
Failing to observe the warnings
above.
●
A non-genuine Toyota suspen-
sion (lowered suspension, etc.)
is installed.
■
Notes when washing the vehi-
cle
Do not apply intensive bursts of
water or steam to the sensor
area.
Doing so may result in the sensor
malfunctioning.
●
When using a high pressure
washer to wash the vehicle, do
not spray the sensors directly,
as doing so may cause a sensor
to malfunction.
●
When using steam to clean the
vehicle, do not direct steam too
close to the sensors as doing so
may cause a sensor to malfunc-
tion.
www.carobook.com