Toshiba TEC B-852-TS12-QQ, Руководство пользователя

Страница: 18 / 118

2. PRINTER SETUP
EO1-33029
2.7 Loading the Media
2- 8
2.7.1 Installing the Media
onto the Supply Holder
Unit (cont.)
The diagram below, and the steps that follow, show the procedures for
installing the Media onto the Supply Shaft and reassembling the Supply
Holder Unit. Be sure to follow the step-by-step procedure exactly or the
auto centering mechanism may not work properly.
Installing the Media and reassembling the Supply Holder Unit
1.
Place the media roll onto the Supply Shaft with the media feeding
from the bottom as shown in the diagram above.
c
2.
Align the tab of the Removable Supply Holder with the Slot in the
Supply Shaft, then reinstall the Removable Supply Holder by sliding it
onto the Supply Shaft as shown in the figure above.
3.
Holding the reassembled Supply Holder Unit in your right hand, apply
pressure only to the reinstalled Removable Supply Holder to push it in
the direction of arrow
d
, causing the auto centering mechanism to
center the media on the Supply Shaft.
4.
Tighten the green Supply Holder Locking Knob for the Removable
Supply Holder by turning it in the direction of arrow
e
.
5.
Tighten the green Supply Holder Locking Knob for the Non-
removable Supply Holder by turning it in the direction of arrow
f
.
NOTES:
1. This supply holder accepts
four sizes of media core: 38
mm, 40 mm, 42 mm and 76.2
mm.. When using a media roll
of 38 mm, 40 mm, or 42 mm,
remove the spacers from the
supply holders by pushing
both hooks of the spacer.
Keep the removed spacers
safe.
2. Use only inside wound label
stock. Outside wound label
stock may not feed properly.
Use outside wound label stock
at your own risk.
3. Do not over-tighten the
green supply holder locking
knob.
CAUTION!
When installing the media
roll, do not push on the
Non-removable Supply
Holder as this will result in
the media roll not being
properly centred.
Supply
Holder
2
3
4
1
Non-removable
Supply Holder
Removable
Supply Holder
Media Roll
Supply Shaft
Print Side
Slot
Tab
1
1
2
Spacer
If you turn the
Removable Supply
Holder side down after
loading the media, the
media may drop by
weight. You might be
injured by the dropped
media.
WARNING!
Green Supply
Holder
Locking Knob