4-32
T200, T200CS
Installing the T200CS Tablet
To install the computer’s tablet, follow the steps below and refer to Figures 4-20 through 4-22.
1.
Place the
tablet
on the display module. When you seat the
tablet
, align the holes at
each corner with the corresponding posts on the LCD module (Figure 4-22).
2.
Lift the cables up and out of the way, then place the
tablet cover
on the
tablet
(Figure
4-21).
3.
Place the
middle frame
on the display module, making sure the cabling is covered, then
snap the
four
latches
into place (Figure 4-20).
4.
Secure the
middle frame
with the
two
M2.5x4 screws
(Figure 4-20).
5.
Install the FL inverter board, lower system board, upper system board, backup battery,
RTC battery, back cover, HDD, optional PCMCIA card, optional memory card, and
battery pack as described in sections 4.2, 4.3, 4.4, 4.5, 4.6, 4.7, 4.8, 4.9 and 4.10.
Содержание T200
