Program 77-1 Peripheral Options (Door Phones) PIOU/PIOUS/IMDU/PEPU
System & Station
Strata DK40 Programming Manual Spring 1999
3-171
Program 77-1 Overview
This program performs the following functions:
◆
Programs door lock relays
◆
Assigns door phones/lock control units
◆
Enables IMDU built-in maintenance modems
◆
Enables DK Admin Communications Protocol
◆
Enables/disables ring tone to external paging when system is in Night mode
◆
Assigns a relay to operate with door lock function or external page for mute control
◆
Assigns a relay to operate in one of two Night Transfer modes
◆
Assigns a relay to operate in one of two applications
LED 20: Door Lock Time
The Door Lock Relay contact may be programmed to operate for either three or six seconds
(applies to PIOU, PIOUS, PEPU, DDCB, and HDCB door lock controls).
LEDs 16~18: Port Number/Door Phone/Lock Control Units
Door phone/lock existence is defined by this program. The door lock option is set via
Program 77-2.
◆
Door phone/lock controllers (DDCBs and/or HDCBs) can only exist on Port 004, and
can only be installed on Circuit 5 of a PDKU or PEKU. PDKUs support DDCBs, but
not HDCBs. PEKUs can support HDCBs, but not DDCBs. After assignment of a DDCB
or HDCB, door phone numbers (#151~#159, #161~#163) effectively replace the station
number assignment in Program 04.
The first DDCB is always Port 004 on the Base KSU Digital Station Card. The port
number of the second and third DDCB/HDCB’s will depend on the configuration of the
Base KSU (i.e. TBSU (NT) or KSTU installed).
Up to three DDCBs/HDCBs can be installed in a DK40. They must be assigned a
PDKU or PEKU port number to operate (DDCB to PDKU and HDCB to PEKU.
(
for door phone ringing assignments)
LED 14: IMDU Modem
This program enables the DK40 built-in maintenance modem function: IMDU.
◆
Turn LED 14 ON if the optional PIOU or PIOUS has Remote Maintenance from the
IMDU modem subassembly. If an IMDU is installed on a DK40 PIOU or PIOUS, it can
be accessed by dialling station #19 (unless the access code prefix has been changed with
Program 05).
Other system Programs that are related to the system modem are:
, system
Exchange line to modem ringing assignments;
CPN to Modem Ringing
Assignments.
LED 10: DK Admin
Enables the system to Upload/Download the CTU RAM data base using Toshiba DK Admin
software.
Содержание Strata AirLink DK40
Страница 1: ...Spring 1999 726 Telecommunications Division Programming Manual ...
Страница 22: ...Introduction Related Documentation xxii Strata DK40DK40 Programming Manual Spring 1999 ...
Страница 246: ...System Station Program 97 Printing Program Data through SMDR 3 188 Strata DK40 Programming Manual Spring 1999 ...
Страница 378: ...GL 8 Strata DK40 Programming Manual Spring 1999 ...