High Wall, Heat Pump Type
Service Manual
97
Toshiba
11-1-6. Heat Exchanger
1) Perform all the steps in
11-1-1.Removing the
Front Panel and Moving Panel
and
11-1-2.
Fixing Frame Assembly
.
2) Remove the pipe holder at the rear of the unit.
3) Remove the two fixing screws (10 mm) at the
left of the heat exchanger.
4) Remove the fixing screw of the heat exchanger
fixing holder (upper).
5) Remove the fixing screw of the heat exchanger
fixing holder (lower).
6) Release the end plate hook and the claw at the
right of the heat exchanger, pull up the heat
exchanger, and then remove the fixing holder
(lower) from the guide of the indoor unit.
CAUTION
Check that the claw is engaged with the end plate hook,
and then secure the heat exchanger with screws.
11-1-7. Fan Motor
1) Perform all the steps in
11-1-1.Removing the
Front Panel and Moving Panel
and
11-1-3.
Electric Parts Cover Detached
.
2) Loosen the hexagon socket set screw of the
cross flow fan from the air outlet.
3) Remove the two fixing screws of the motor
band (right).
4) Pull the motor band (right) and the fan motor
out of the unit.
CAUTION
Install the fan motor while positioning it so that the fan
motor connector comes between the positioning ribs on
the motor band (right).
Be sure to tighten the hexagon socket set screw so that
it touches the D-cut surface of the fan motor shaft.
Pipe holder
Screw
(10 mm)
Heat exchanger
fixing holder
(upper)
Heat exchanger
fixing holder
(lower)
Hexagon socket set screw
Fixing screws
Motor band (right)
Motor band (right)
Motor connector
Positioning ribs
+00A08-010_01EN_SVM_HighWallHeatPump.book Page 97 Wednesday, March 4, 2009 11:22 AM
