Introduction
16
NOTES: •
A clear picture will not be obtained by the DVD/VCR unless the antenna signal is good. Connect the
antenna to the DVD/VCR properly.
•
For better quality recording, an indoor antenna or a telescopic antenna is not recommended. The use
of an outdoor type antenna is required.
•
If you are not sure about the connection, please refer to qualified service personnel.
If you are using an antenna system, follow these instructions. If you are using a Cable TV subscriber, skip
ahead to page 18 for the proper connections.
ANTENNA TO DVD/VCR CONNECTION
The DVD/VCR must be connected “between” the antenna and the TV. First, disconnect the antenna from the TV
and connect it to the DVD/VCR. Then connect the DVD/VCR to the TV. Below are 3 common methods of connect-
ing an antenna system to a DVD/VCR. Find the type of antenna system you are using and follow the connection
diagram.
If both UHF and VHF antennas have 300 ohm twin lead (flat) wires,
use a combiner having two 300 ohm inputs and one 75 ohm output.
NOTE:
Antenna connections
Combination UHF/VHF antenna with 75 ohm coaxial cable
Combination UHF/VHF antenna with 300 ohm twin lead (flat) wire
Separate UHF and VHF antennas
1
2
3
!"
%& !
#"
"#"
!"##
!
#"
"#"
!"##
DVD/VCR
75 ohm coaxial cable
75
2J41101B_E P12-22
5/28/07, 12:03 PM
16