Toshiba B-EX4T1-T JP, Руководство по эксплуатации

Страница: 78 / 115

By sending the created print command to the printer in which the external character file is stored, you can
print the external characters for check.
The file extension is "prn" and the file name is the same as the output file name.
When "Folder" is selected for [Specification Method], this becomes invalid.
[Magnification]
Selects a magnification of the external character for test print.
Default 1.0 x 1.0
Options 0.5 x 0.5, 1.0 x 1.0, 2.0 x 2.0, 3.0 x 3.0, 1.0 x 2.0, 2.0 x 1.0
[Print Method]
Selects the print method.
Default
Other than B-EX4D2-G/T (203dpi/300dpi): Thermal Transfer
B-EX4D2-G/T (203dpi/300dpi): Direct Thermal
Options
B-EX4T1-G/T (203dpi/305dpi) / B-EX4T1-T JP (305dpi):
Thermal Transfer, Thermal Transfer (Ribbon Saving), Direct Thermal,
Direct Thermal (Head Up)
B-EX4T2-G/T (203dpi/300dpi) / B-EX4T2-H (600dpi):
Thermal Transfer, Direct Thermal
B-EX4T3-H (600dpi): Thermal Transfer
B-EX4D2-G/T (203dpi/300dpi): Direct Thermal
[Label Length]
Sets the effective print length of media. The label gap is fixed to 2 mm.
Default 74 mm
Range
Other than B-EX4T2-H (600dpi) / B-EX4T3-H (600dpi): 8 to 1498 mm
B-EX4T2-H (600dpi) / B-EX4T3-H (600dpi): 8 to 498 mm
[Label Width]
Sets the effective print width of media.
Default 54 mm
Range 10 to54 mm
[Output File]
Specifies the file where an external character is stored.
Click the button to display the file selection screen. Specify a file and click [Save]. Then, the full
path is displayed in the file name.
The file extension is "gai".
After the specified file is initialized, an external character is stored in it.
[Create]
A Bitmap External Character Command is created from the bitmap on the specified conditions.
When this button is clicked, the processing starts.
The progress status is indicated with the progress bar. Cancellation is not acceptable during the
creation of the command.
This button is grayed out unless data are set for [Bitmap Path] and [Output File].
When "File" is selected for [Specification Method], an external character file is created from the specified
bitmap file.
When "Folder" is selected for [Specification Method], an external character file is created from the bitmap
file in the Bitmap list.
A Bitmap External Character Command is created with nibble data.
Send the created external character files to the printer using [Send File] on the [Tool] tab page.
When reading, creating or saving the external character files failed, an error message will be displayed.