21
Turning the TV on
Switching on the TV
Connect the power cord to the TV and a wall
outlet (
☞
page 19).
1
Press
POWER
on the right side of TV or on
the remote control.
CABLE
Stereo
SAP
100
The
POWER
indicator lights in green.
Note:
If you watch black and white programs
when the color system mode is set to Auto,
color noise may appear on the screen. In
this case select the appropriate Color system
(
☞
page
22).
Switching the TV to standby mode
Press
POWER
on the remote control or on the
TV side panel to switch to the standby mode.
The
POWER
indicator lights up in red.
Note:
This TV is not fully disconnected from the
main supply, as minute current is consumed
even when
POWER
is in standby mode. When
the TV will not be used for a long period of time,
such as during vacation or travel, remove the
power plug from the wall outlet.
Understanding the auto power off feature
The TV will automatically turn itself off after
approximately 15 minutes if it is tuned to a
vacant channel or a station that completes its
broadcast for the day. This feature does not work
in video input mode.
Understanding the last mode memory
feature
If the power is cut off while you are viewing the
TV, the Last Mode Memory feature automatically
turns on the TV when the power is resupplied.
Note:
You should unplug the TV’s power cord if
it is possible that you will be away from the TV
for an extended period of time after the power is
restored. This will prevent the TV from turning on
in your absense.
Selecting the menu language
You can choose from three different languages
(English, French and Spanish) for the on-screen
display of menus and messages.
1
Press
MENU
, then press
1
or
2
to display
Set Up
menu.
2
Press
s
or
t
to highlight
Language
.
System
OK
CH Program
OK
Picture Position
TV/CABLE
Language
Set Up
MENU
Back
Watch TV
EXIT
English
TV
Auto
Add/Erase
Add
3
Press
1
or
2
to display your desired
language.
4
Press
EXIT
to close the
Set Up
menu.
Programming channels into the TV’s
channel memory
When you press
CH
s
or
CH
t
on the remote
control or TV control panel, your TV will stop
only on the channels you program into the TV’s
channel memory.
Follow the steps below to program channels into
the TV’s channel memory.
Programming channels automatically
Your TV can automatically detect all active
channels in your area and store them in its
memory. After the channels are programmed
automatically, you can manually add or erase
individual channels in the channel memory.
Note:
• If the input signal type is set to
CABLE
for
an antenna input, the automatic channel
programming process erases channels that
were previously programmed into the TV’s
memory.
• If the input signal type is set to
TV
, the
automatic channel programming process does
NOT erase channels that were previously
programmed into the TV’s memory, but adds
newly found channels to the existing set of
programmed channels. To remove a channel
from the memory, you must manually delete it.
• To tune the TV to a channel not programmed
in the channel memory, you must use the
Channel Number buttons on the remote
control.
Chapter 4: Setting up your TV
20DL77_En_new23.indd 21
20DL77_En_new23.indd 21
6/13/07 3:50:54 PM
6/13/07 3:50:54 PM
