TOS SUA 125 NUMERIC, Руководство по эксплуатации

Страница: 17 / 118

SUA 125 NUMERIC
34200003 TOS a.s. 02/2011
17
2.5. Universal safety, ecological and hygienic demands applied to conceptional lathe
version of SUA 125 NUMERIC with EU Standards.
Noise.
There are suitable means to minimalize risks cased by noise, for example decrease of supply noise or absorption of emitting
noise.
If the conditions for noise test are not at disposal, the noise declaration gives following data:
- arrangement and lathe working conditions in case of measuring of emitting noise.
- position of working place where the levels of acoustic pressure were measured.
- method used for measuring
- tests according to them the declaration of noise level is worked.
Information of noise spreading by air is mentioned in accordance with used measuring methods and in accordance with
working conditions specified in relevant EN National Standards.
Note:
Noise measuring is worked according to the Czech National Standard NSST 20 102 “Noisiness of metal machine tools“.
Lighting
Lighting of working area is worked such a way so that the motion of cutting process could be visible through the inspection
hole and its intensity should be at least 300 luxs measured before the end of work spindle at the distance corresponding to
chuck diameter.
Electrical equipment
Electrical equipment is pursuant to EN 60204-1.
Ergonomy
The lathe is designed in accordance with ergonomical principles mentioned in EN 292-1, the article 4.9, EN 292-2, the
articles 3.6 and 6.2.4, EN 547-1 and 2 and ENV 26385.
Where there is a device for workpiece handling required a measure for their instalation and activity is possible in open
shields, e.g. by forming approach from the top of the machine, by lifting mechanizm, etc..
Cutting lubricants
The lathe is designed to enable a maintenance of cutting lubricant, e.g. to take samples, cleaning of tanks and tubes and
filter exchanche so that a leakage, pouring and possible contact with lubricant, etc. are prevented.
Tanks and tubes for cutting lubricant are designed such a way so that the place with immovable lubricant is not occured
during circulation.
Hydraulic system
To avoid risks arising from hydraulic system the lathe is made in accordance with EN 982.
Disconnection
See EN 292-2, the articles 3.8 and 6.2.2.
An electric disconnecting switch is in accordance with the article 5.3 in EN 60204-1 ( disconnecting switch is not the d type
) in the article 5.3.2.
Maintenance
See EN 292-2, the article 3.12 and the supplement A, EN 292-1, the article 1.6.1.
The information of maintenance in examples according to EN 292-1, the article 5.5.1 is mentioned in this Manual.