The AC power connector jack and fuse holder are a module mounted on the rear of the unit. The
temperature probe jack and RS232 I/O port jacks are on the rear panel as well. Note the polarity
on the probe jack. Be sure not to force this connection when plugging in the temperature probe.
The AC power jack is a three-prong, male plug combining the snap-in fuse holder. The fuse
types used appear on the label on the rear of the unit.
CAUTION: If the fuses blow repeatedly, contact your dealer or the manufacturer.
ATTENTION: Si les fusibles sautent de manière répétitive, contacter votre distributeur
habituel ou le fabricant.
The temperature sensor jack is a 5-pin DIN jack which is used with a 100-ohm at 0
Ε
C platinum
RTD temperature probe. Only pins 1, 3 and 5 are used.
7
VIII. SET UP PARAMETERS AND INSTRUCTIONS
The HP60 & HS60 Programmable Ho t Plates & Hot Plate/Stirrers are very simple instruments
to use. Follow the instructions below.
