Toro TimeCutter MX 4260, Руководство оператора

Страница: 40 / 52

3
G005074
1
2
3
4
5
6
Figure 51
1. Hanger bracket 4. Eccentric adjustment plate
2. Rear locking nut 5. Socket wrench hole
3. Side locking nut 6. Socket wrench with 3/8
inch extension
Adjusting the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install
the mower. If the front of the mower is more than
5/16 inch (7.9 mm) lower than the rear of the mower,
adjust the blade level using the following instructions:
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
park position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Set the height-of-cut lever to middle position.
Note:
Check and adjust the side-to-side blade
level. If you have not checked the setting; refer to
Side-to-Side Leveling.
4. Carefully rotate the blades so they are facing front
to rear (Figure 52).
G009658
1
2
2
Figure 52
1. Blades front to rear
2. Measure from the tip of the blade to the flat surface here
5. Measure from the tip of the front blade to the flat
surface and the tip of the rear blade to the flat
surface (Figure 52). If the front blade tip is not
1/16-5/16 inch (1.6-7.9 mm) lower than the rear
blade tip, adjust the front locknut.
6. To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower (Figure 53).
G014634
1
2
3
Figure 53
1. Adjusting rod 3. Lock nut
2. Adjusting block
7. To raise the front of the mower, tighten the
adjustment nut. To lower the front of the mower,
loosen the adjustment nut.
8. After adjustment, check the front-to-rear slope again.
Continue adjusting the nut until the front blade tip
is 1/16-5/16 inch (1.6-7.9 mm) lower than the rear
blade tip (Figure 52).
9. When the front-to-rear blade slope is correct check
the side-to-side level of the mower again; refer to
Leveling the Mower from Side-to-Side.
40