Toro TimeCutter HD X5450, Руководство оператора

Страница: 47 / 60

g024313
Figure 72
1. Deck-lift arm
3. Hook
2. Chain 4. Adjustment bolt
6. Ensure that there is tension on all 4 chains ( Figure 72 ).
7. Tighten the 4 adjustment bolts ( Figure 72 ).
8. Ensure that the blocks fit snugly under the deck skirt
and that all bolts are tight.
9. Verify that the deck is level by checking the side-to-side
level and front-to-rear blade slope; repeat the deck
leveling procedure if necessary.
Removing the Mower Deck
Park the machine on a level surface, disengage the
blade-control switch, move the motion-control levers outward
to the N
EUTRAL
-L
OCK
position, engage the parking brake,
shut off the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
Lower the mower to the lowest height of cut. Select one of
the following procedures depending on the mower deck size
installed to complete the removal.
Preparing to Remove the Mower Deck
1. Lower the mower to the 76 mm (3 inches) height-of-cut
position.
2. Loosen the 2 bottom bolts holding the mower-deck
curtain to the mower deck; refer to
Releasing the
Mower-Deck Curtain (page 33) .
3. Remove the mower belt from the engine pulley; refer
to
Replacing the Mower Belt (page 49) .
Removing the Mower Deck
1. Remove the hairpin cotter and washer securing the
link pin to the frame and deck, and remove the link
bar (
Figure 73 ).
g028276
Figure 73
1. Link pin 3. Hairpin cotter
2. Washer
2. Lift up the mower deck to relieve tension from the
mower deck.
3. Remove the chains from the hooks on the deck-lift
arms (
Figure 74 ).
g024313
Figure 74
1. Deck-lift arm 3. Hook
2. Chain 4. Adjustment bolt
4. Raise the height of cut to the transport position.
5. Remove the belt from the clutch pulley on the engine.
6. Slide the mower out from underneath the machine.
Note:
Retain all parts for future installation.
47