Toro TimeCutter HD X5450, Руководство оператора

Страница: 23 / 60

Using the Side Discharge
The mower has a hinged grass deflector that disperses
clippings to the side and down toward the turf.
DANGER
Without a grass deflector, discharge cover, or a
complete grass-catcher assembly mounted in
place, you and others are exposed to blade contact
and thrown debris. Contact with rotating mower
blade(s) and thrown debris will cause injury or
death.
• Never remove the grass deflector from the mower
because the grass deflector routes material down
toward the turf. If the grass deflector is ever
damaged, replace it immediately.
• Never put your hands or feet under the mower.
• Never try to clear the discharge area or mower
blades unless you move the blade-control switch
(PTO) to the O
FF
position, rotate the ignition
key to the O
FF
position, and remove the key.
• Make sure that the grass deflector is in the down
position.
Adjusting the Height of Cut
The machine is equipped with a foot pedal deck-lift system.
You can use the foot pedal to lift the deck briefly to avoid
obstacles or lock the deck in the highest height of cut or
transport position. You can use the height-of-cut lever with
the foot pedal to lock the deck in a specific cutting height.
Using the Foot Pedal Deck-Lift System
• Press the deck-lift pedal down to raise the deck; continue
to press the pedal until the deck locks in the transport
position (
Figure 27 ).
•
Push on the deck-lift pedal with your foot and pull the
transport lock handle rearward to disengage the transport
lock (
Figure 27 ).
g024409
g024409
Figure 27
Transport Lock Position
Adjusting the Height of Cut
You can adjust the height of cut from 38 to 114 mm (1-1/2
to 4-1/2 inches) in 6 mm (1/4 inch) increments by relocating
the height-of-cut pin into different hole locations.
1. Push on the deck-lift pedal with your foot and raise
the mower deck to the transport-lock position (also
the 114 mm (4-1/2 inches) cutting height position) as
shown in
Figure 28 .
2. To adjust, remove the pin from the height-of-cut
bracket (
Figure 28 ).
3. Select a hole in the height-of-cut system corresponding
to the desired height of cut and insert the pin (
Figure
28 ).
23