Problem
Possible Cause
Corrective Action
1. The key was turned to the Start position
before the glow plug light turned off.
1. Turn the key to the Run position and
allow the glow plug light to turn off
before starting the engine.
2. The engine temperature is low.
2. Check the thermostat and replace it if
necessary.
3. The glow plugs are not operating.
3. Check the fuse, glow plugs, and wiring.
4. The injection pump timing is incorrect.
4. Contact your Authorized Service
Dealer.
5. The injection nozzles are damaged.
5. Contact your Authorized Service
Dealer.
There is excessive white smoke in the
exhaust.
6. The engine has low compression.
6. Contact your Authorized Service
Dealer.
1. The engine is under an excessive load.
1. Reduce the ground speed of the
machine.
2. The engine oil level is either too low or
too high.
2. Either add or drain the engine oil until
the oil level is at the Full mark.
3. The air cleaning system elements are
dirty.
3. Service the air cleaning system
elements.
4. There is dirt or water in the fuel system.
4. Drain and flush the fuel system; add
fresh fuel.
5. The engine overheats.
5. Check the engine oil level and add oil
as needed; also check and service the
coolant system, if necessary.
6. There is air in the fuel.
6. Bleed the nozzle and check for air
leaks at the fuel hose connections and
the fittings between the fuel tank and
the engine.
7. The engine has low compression.
7. Contact your Authorized Service
Dealer.
8. The fuel tank vent is restricted.
8. Loosen the cap. If the engine runs with
the cap loosened, replace the cap.
9. The injection pump timing is incorrect.
9. Contact your Authorized Service
Dealer.
The engine loses power.
10. The injection pump is damaged.
10. Contact your Authorized Service
Dealer.
1. The parking brake is engaged.
1. Release the parking brake.
2. The hydraulic fluid level is low.
2. Add hydraulic fluid to the reservoir.
3. The tow valves are open.
3. Close the tow valves.
4. The pump and/or motor is damaged.
4. Contact your Authorized Service
Dealer.
The machine does not drive.
5. The relief valve is damaged.
5. Contact your Authorized Service
Dealer.
70
Содержание RT600
Страница 71: ...Notes 71...
