Figure 29
3. Secure the guard mounting tubes to the side plates
with (4) screws, flat washers and nuts (Figure 28).
Note:
Use the remaining washers, as required, to fill
any gap between the tubes and the aerator side plates.
15
Installing the Latch Lock
Parts needed for this procedure:
2
Lock plate
2
Tap bolt
2
Retaining ring
Procedure
1. Position the latch plate over the hood latch while
aligning the mounting hole with the hole in the side
plate (Figure 30).
Figure 30
1.
Retaining ring
3.
Latch plate
2.
Mounting hole
4.
Tap bolt
2. Secure the latch plate to the side plate with a tap bolt
and a retaining ring (Figure 30).
3. Repeat the procedure on the other hood latch.
16
Removing the Storage Stands
(Models SR54 and SR70 )
No Parts Required
Procedure
1. Raise the aerator roller(s) 3-6 inches off ground.
Place support blocks under the roller(s).
2. Remove the bolts, lock washers and nuts securing the
storage stands to each end of the aerator (Figure 31).
20
