Toro Multi Pro WM, Руководство оператора

Страница: 26 / 96

11
Installing the Sprayer Fuse
Block
Parts needed for this procedure:
1 Fuse decal (127–3966)
Procedure
1. At the control console for the sprayer, route the
branch of the front wire harness with the fuse
blocks between the bottom of the dash panel
and the cross tube of the machine chassis and
down toward the forward side of the fuse block
of the machine (
Figure 24 ).
g033528
Figure 24
1. Fuse blocks (front wire
harness—control console) 2. Cross tube (machine
chassis)
2. Locate the uninsulated receptacle terminal at
the end of the open, yellow power wire of the
fuse block for the machine and the insulated
blade terminal at the end of the yellow, optional
power wire of the fuse block of the sprayer
wiring (
Figure 25 ).
g033529
Figure 25
1. Uninsulated receptacle
terminal (yellow,
optional-power
wire—sprayer fuse block) 4. Fuse block (sprayer
wiring)
2. Insulated blade terminal
(yellow, optional-power
wire—sprayer fuse block) 5. Uninsulated receptacle
terminal (yellow power
wire—machine fuse block)
3. Back of the machine 6. Fuse block (machine
wiring)
3. Connect the uninsulated receptacle terminal of
the fuse block for the machine to the insulated
blade terminal of the fuse block of the sprayer
(
Figure 25 ).
4. Align the T-fittings on the of the fuse block of
the sprayer to the T-slots of the fuse block for
the machine and slide the sprayer fuse block
into the slots until the fuse block is fully seated
(
Figure 26 ).
26